Hey, is it possible to have the elevation concept (picture 2) near the prototype? Is there any official tool that support this or I can just design it with the pen in the side?
Hello,
the dimensions of the elements are displayed in the tab layer, unfortunately we do not have an element that shows it as a graphic near the element.
greetings
Ria.
Replies have been locked on this page!
Hello,
the dimensions of the elements are displayed in the tab layer, unfortunately we do not have an element that shows it as a graphic near the element.
greetings
Ria.
Hello,
the dimensions of the elements are displayed in the tab layer, unfortunately we do not have an element that shows it as a graphic near the element.
greetings
Ria.
Hello,
the dimensions of the elements are displayed in the tab layer, unfortunately we do not have an element that shows it as a graphic near the element.
greetings
Ria.
Hello,
the dimensions of the elements are displayed in the tab layer, unfortunately we do not have an element that shows it as a graphic near the element.
greetings
Ria.
Replies have been locked on this page!